Slashdot is powered by your submissions, so send in your scoop

 



Forgot your password?
typodupeerror
×
Hardware

Raspberry Pi's PoE HAT Ships For $20, Tosses in a Free Fan (linuxgizmos.com) 90

Raspberry Pi is offering a Power-over-Ethernet HAT board for the RPi 3 Model B+ for $20 that ships with a small fan. Per blog LinuxGizmo, the "802.3af-compliant 'Raspberry Pi PoE HAT' allows delivery of up to 15W over the RPi 3 B+'s USB-based GbE port without reducing the port's up to 300Mbps bandwidth." From the report: The Raspberry Pi PoE HAT features a fully isolated switched-mode power supply with 37-57V DC, Class 2 input and 5V/2.5A DC output. The HAT connects to both the 40-pin header and a new PoE-specific 4-pin header introduced with the B+ located near the USB ports. To enable PoE, you need power sourcing equipment, which is either "provided by your network switch or with power injectors on an Ethernet cable," writes the foundation in a blog post.
This discussion has been archived. No new comments can be posted.

Raspberry Pi's PoE HAT Ships For $20, Tosses in a Free Fan

Comments Filter:
  • This is VHS against Betamax all over,

    • I'm just disappointed it's not really a hat. I thought this was a wearable joke computer and I clicked on the link so see what its power supply was.

  • A fan is nice, but what is this thing's environmental specs these days?

    • by Zmobie ( 2478450 )

      If I'm looking at the pictures right, that fan also seems to cover the GPIO pins entirely... Wouldn't that kill a ton of use cases for someone deploying this thing remotely with a PoE setup?

  • any IO will slow the 1 USB bus on this

  • Lots of these Pi accessories are neat, but completely ruin its ability to be sealed in a case. It looks like this one will fit.

    Any ideas?
  • If I wanted to pay $20 for a mere module, I would buy a whole PC.

    Where are the disposable computers you can buy in a 12-pack at the discount store?

  • by Locke2005 ( 849178 ) on Monday August 27, 2018 @05:51PM (#57206334)
    1) What is a HAT? 2) Can I make one for my ARM Serial Signal processor, to be referred to simply as an ASSHAT?
  • I get the impression the costs are slowly creeping on this thing and the features kinda stagnant.

    Firstly, to my knowledge, it's STILL 100Mbit networking isn't it? Routed through USB somehow? For most Pi functions, this isn't going to impact people, but if you are an American / European running a Pi and using it as a regular speed test unit
    https://www.google.com/search?... [google.com]

    You'll see that anyone with a particularly beefy internet connection will be limited.
    Also the CPU is almost good enough to perform ligh

    • and the features kinda stagnant.

      Counterargument: That's not the point. This isn't an iPhone keynote where hype generation is a part of the process. RasPi has been being on having an open source hardware design and a low barrier to entry that enables everything from amateur electronics with its GPIO to being an inexpensive first computer for programming and development to the ability to turn it into an appliance for anything from a Chromecast alternative to a home automation system powered by an Ocarina. It may not have whizbang features o

  • Or you could get one that doesn't block all the IO pins https://amazon.com/NavoLabs-Ra... [amazon.com]

  • In our testing with Raspberry Pi's (Specifically The RPi 3 B+) total hardware I/O has never exceeded 22MB/s. On the note of better quality chips with a higher process tends to cost more on the hardware side, and kernel development to build around a newer chip will take time. It's a bit of a double-edged sword pushing a simple SBC from as cheap as $3 to make and pushing it to $75 or more to make completely negating the purpose of inexpensive computing solutions for small projects. No matter how you slice it,

Ya'll hear about the geometer who went to the beach to catch some rays and became a tangent ?

Working...