@HiThere.
Thanks!
I forgot to mention, if you are in the U.S.A, then is is also quicker chipping wise to go with dorkbotpdx mentioned above. Simply for shipping times alone. Seeedstudio's fusion service only e-tests 50% of the boards by default. Even then, I have still had boars that pass e-test, but where the copper meets the pad, it is too thin. This will break the connection. Yes, plated through holes are a little bit harder to re-wrok, but with a little flux and the heat turned down, it is do-able. I have ordered from Seeedstudio's fusion service over 10 times. Although they are cheaper, I ended up spending more time repairing bad boards. I have switch to dorkbotpdx and have not looked back.
There is also batchpcb, but their prices are higher. Also last time I check batchpcb only had green silkscreen and a minimum of 8 mil traces.
-JC