check

check

not yet, but it has been half way off the table and just about ready too... If it did I'd be more woried about the printer: I can print a replacement foot with my printer, but no matter how much I try my foot refuses to make me even the simplest printing press.

hahaha... you'd better hold your breath untill the build finishes :p

Am I the only one sick of having to paste that link under all these "all plastics are bad" comments? :p I'm glad you beat me too this one.

We all know what "Dust" realy is.

Wrong... try again.

(Just incase you can't be bothered reading... the summary is that implants are made out of PLA because it degrades in such a "good" way)

Here here!

... but it's not really an eithor/or situation... we had a hung parliment _and_ we got spied on.

I think the closest you'll find would be the rasberry Pi.

Keeping up to date with the mainline kernel would be expensive, and would gain you very little in the embedded market... people there want cheap and reliable and will give up features to get it... That's my impression anyway.

Worse, If you tell your friend: "I found this great info on you should look at it" then the librarian hands them different books... at the same time.

I was wondering if it was just me... this sucks.