Not OP, but the US tape measures are much better than the metric equivalent. US has a large mark every half inch, a slightly smaller mark at 1/4 inch, 3/4 inch. then all the remaining marks slightly smaller at 1/8, and then smallest every 1/16". Without any numbers, you can do many many more iterations than divide by than 1/10th can do for framing, building houses, etc it is truly better. Especially that squares can skip the 1/8", and 1/16" marks that can't be so easily stamped into them for endurance, yet you can easily transfer measurements from this device with 1/4 as many marks as the tape measure back and forth, just looking for identical marks. 1/10 just doesn't scale like that, you can't skip half the decimal marks and not be lost, you can't just look at a tape, and no the difference without counting from 0.2 to 0.3.
in your example, 0.25 your going to be approximating on a metric tape, where is half way between .2, and .3, so you will be counting each mark, 1,2,3 ok half way between the 2 and 3. With the US tape, if your a carpenter used to it, you know what a 1/4 mark looks like, so you can just see it and mark it. May not seam like much, but it truly save a second on every measurement. And it works for all the marks, what 15/32", the 1/2" mark is obvious, move up one of the smallest marks, want 9/16", go up by one of the 1/16 marks.