Comment Re:best idea? (Score 2) 174
Adding to this since it is the best suggestion so far....I'm not sure I'd use etching stuff rather than a standard pegboard piece if I'm just hacking... if I'm finished then order one to be printed. Not sure about a couple of the bigger tools but it all depends on the project (could also go to manual tools if they wont be used much).
wall of drawers with millions of little compartments for components.
wire stripper
proper multimeter, capacitance meter
lots of wire!
Variable power supply
Scope/logic tester
solder station: Copper braid,solder,solder pumps, variable temp solder iron, brass sponge, flux pen, stand
May need a fan depending on ventilation or you'll all get sick and die.
heat shrink tubing
heat gun (for soldering surface mount chips or other annoying stuff)
Lots of handy outlets.
That said i'm thinking of a small robotics/electronics lab. Nothing heavy mechanical.
wall of drawers with millions of little compartments for components.
wire stripper
proper multimeter, capacitance meter
lots of wire!
Variable power supply
Scope/logic tester
solder station: Copper braid,solder,solder pumps, variable temp solder iron, brass sponge, flux pen, stand
May need a fan depending on ventilation or you'll all get sick and die.
heat shrink tubing
heat gun (for soldering surface mount chips or other annoying stuff)
Lots of handy outlets.
That said i'm thinking of a small robotics/electronics lab. Nothing heavy mechanical.