Want to read Slashdot from your mobile device? Point it at m.slashdot.org and keep reading!


Forgot your password?
Check out the new SourceForge HTML5 internet speed test! No Flash necessary and runs on all devices. ×

Submission + - Machining A TI-89 Aluminum (hackaday.com)

TangoMargarine writes: Sometimes, expensive calculators hit the floor. It’s happened to almost anyone with a graphing calculator from TI or HP. Sadly, they don’t always bounce. After this happened to [Howard C.], an Industrial Engineering student from U. of Iowa, he decided to spend $50 on milling his own replacement case out of aluminum rather than trashing the device over a broken battery compartment.
This discussion was created for logged-in users only, but now has been archived. No new comments can be posted.

Machining A TI-89 Aluminum

Comments Filter:

I've looked at the listing, and it's right! -- Joel Halpern