1. The very initial step to putting in a dish process is to do a internet site survey.

Make positive that you have a clear line of site to the South wherever you will be mounting the dish, and obtain something sound to mount it to. Perfect destinations would consist of the corner or facet of the household exactly where you can mount the mast into a wall stud, a sound immovable submit, or as a last resort, the roof. It is okay to mount the dish to a roof, however retain in head that you will be penetrating it with lag bolts that will want to be weatherproofed with silicone or roofing sealant.

Continue to keep in mind where the receivers are situated in the house so that you can approach your cable routing accordingly and exactly where you can ground your dish if you want to make your set up NEC compliant.

Make positive that your watch to the Southern sky is unobstructed at the elevation angle you will be setting your dish at. If the setting for your zip code is 45 degrees, examine the sky at a 45 degree angle to make confident the sky is clear.

2. Mount the mast to a reliable surface area utilizing lag bolts.

Use six lag bolts to mount the mast. two inch lags for the corners and three inch lags for the middle holes into a wall stud. Failure to comply with this stage could permit wind weathering to pull and put on on the mast allowing it to strip the hold on the bolts and your dish will gradually move out of alignment. Use a level to make confident that the end of your mast is plumb or (perfectly vertical at each angle). If you don't, it will make it much more difficult to level the dish and get a good signal. The moment your mast is plumb, tighten all the nuts and bolts but do not strip them.

three. Mount the dish to the mast.

Tighten all the bolts and nuts just sufficient to take all the free "play" out of the movement of the dish. Get the coordinates from the receiver setup process for your zip code and alter your azimuth, elevation, and skew accordingly. Use a compass to get a "very best guess" for the azimuth. Do not tighten the bolts however maintain them loose so that you can easily modify them when you very good tune your signal.

four. Connect your signal meter to the LNB and line coming from the receiver.

If you never have a signal meter you can choose just one up from Radio Shack, other electronics supply or the net for about $20 for a low-cost one. satellite meter"
Link to Original Source